Controlling Step Motors Using Arduino

Here you need Arduino uno board, step motor and its driver and a bread board.  this is only to show the pin connections.

Transcript

00:00 Hello everyone, welcome to SIR TV and today I'm trying to control a step motor

00:04 using Arduino and I need the breadboard for the connection and

00:09 this driver, okay, so

00:12 My connection I used pin number four seven eight and twelve. Okay, so it's very basic

00:19 You need the ground and positive five volts here. Then you are going to tap this

00:28 So once you are able to load the program we're going to try it

00:32 So far, I'm not done with the program yet, but I hope that this connection will work

00:39 So see you again. I'll update you once the code is

00:42 Fully written and when it's fully uploaded. Bye guys. See you again in my next videos

00:48 [BLANK_AUDIO]