3 Tricks To Help You Save On Heating Costs

  • 5 years ago
Thanks for watching and don't forget to subscribe for more fun facts, clever ideas, life hacks, and DIY tips & tricks! You can find the full information for this video on our website or below.

Save on Pinterest: https://bit.ly/2EbGc9t
Bookmark Article: https://www.cleverly.me/save-on-heating-costs

***********************************************************************

1. Detecting a Draft

You'll need:

- tea light or candle

When you notice that there's a draft, but don't know exactly where the cold is coming from, then place a tea light or a candle in the place you suspect.  This will most likely be near a window or on the floor in front of the door to the room. Just look where the flame flickers. In this spot, you can use Trick #2.

---

2. DIY Draft Stopper

You'll need:

- 2 empty rolls of gift wrap
- 1 thick pair of pantyhose
- 1 fluffy hand towel

As you've already found out where the cold air is coming from, there are at least two possibilities for crafting solutions against it.

1. The first one is particularly suitable for doors: for this one, first spread the pantyhose out in front of you and cut away one of the legs. Pull the cut-off leg completely over both cardboard rolls and tuck the open end inside one of the cardboard tubes. Stick the pantyhose in place with a few strips of tape, if the fabric doesn't stay in place.

2. The job is done as soon as you install your draft stopper so that there is a cardboard tube either side of the door. The great thing about this trick is that it doesn't cause any problems when it comes to opening and closing the door.

3. The fluffy hand towel is best deployed when cold air is coming through the window. Roll the hand towel up tight and place it directly on the windowsill under the window. That's an end to the cold for now.

---

3. Tea Light Heating

You'll need:

- 2 clay pots of different sizes (each with a hole in the bottom)
- 1 bolt with a screw thread (12 - 14 in)
- 3 nuts
- 3 washers
- 2 bricks
- 1 plate
- at least 2 tea lights

1. First, screw a nut on to the bolt and place a washer on top of it. Stand the larger clay pot on its head and feed the bolt through the hole in the middle. Then turn the pot over. It should now be standing on the washer and the nut. Now place another washer on the bolt, then screw a bolt on. Then, again, place another washer on the bolt before sliding on the smaller clay pot, followed by the last washer and the last nut.

2. Now you just have to bring the individual components of the heating system together: to do this, lie the bricks parallel to each other on the floor. Leave space in between them for your heat source: a plate with the lit tea lights. Finally, set the upturned clay pot construction on the top of the bricks. The pots should be directly over the tea lights.

3. That should offer some respite from the cold for now. Maybe you should acquire a bulk pack of tea lights if you want to use the heating system for longer.

Recommended