Printing Is-3 Tank with 3D printer Prusa I3, and a Slic3r error.
- 7 лет назад
Printing 1:100 Russian Is-3 Tank with my Prusa I3 3D printer.\r
Material PLA. Model downloaded from Thingiverse: \r
\r
You can also see that the Slic3r result should be inspected. The overflow of filament caused the raised surface. Eventually the nozzle hit the plastic and the motor skipped some steps, as a result printer starting to print in offset location. If I hadnt stop the print there would be more damage than now. From a distance it is barely noticeable the print fault and that there are about 5 layers left unprinted..\r
\r
Music by: Approaching Nirvana - Icy\r
\r
Buy music here:\r
iTunes: \r
Amazon: \r
Spotify: \r
Bandcamp:
Material PLA. Model downloaded from Thingiverse: \r
\r
You can also see that the Slic3r result should be inspected. The overflow of filament caused the raised surface. Eventually the nozzle hit the plastic and the motor skipped some steps, as a result printer starting to print in offset location. If I hadnt stop the print there would be more damage than now. From a distance it is barely noticeable the print fault and that there are about 5 layers left unprinted..\r
\r
Music by: Approaching Nirvana - Icy\r
\r
Buy music here:\r
iTunes: \r
Amazon: \r
Spotify: \r
Bandcamp: